Diag led to the cooling fan clutch freewheeling during idle operation. fan was commanded on at 75% but fan continued to freewheel and no airflow felt from fan. Verified the ignition power to fan connector and a ground circuit. Advising to replace the coolinig fan electric clutch and reevaluate.
the cargo light and the third brake light. check all clearance lights also. Test cargo light operation and was able to light both with a power probe. the third brake light was clearly blown and had heat damage to lens and socket. was able to reuse this time. verified third brake light now functioning while testing.
completed. replaced the cooling fan clutch. verified that the fan no longer freewheels at idle. can hear the fan noise now with ac on. ac now cold at idle while testing.
John B. gave our service a 5 star review on 6/9/2021
scanned ebcm found 3 codes c1440 c116a c1963 cleared codes and test drove as needed code c1440 returned for brake pressure circuit diagnose as needed found internal failure in the abs control module no available parts at this time according to ford motor company repair cost to exceed $1600
Burr Y. gave our service a 5 star review on 4/15/2021
Confirmed that vehicle does wander. on accel goes to the right and on decel goes to the left. ABS code for a fault left rear wheel bearing and abs tone ring. Ultimately found right front forward control arm bushing with excessive play/movement.
replaced left rear wheel hub.
Kristi K. gave our service a 5 star review on 1/26/2021
inspect as needed left rear axle seal seeping tailshaft seal seeping check engine light on p0128 code for thermostat
Removed one of the cooler lines and ran the transmission fluid through the system until the fluid started coming out clean and red. Test drove and verified the transmission shifts fine. Job completed.
Larry L. gave our service a 5 star review on 12/16/2020
1. Lubricate and checked chassis. Changed oil and oil filter. Checked all fluid levels and topped off fluids that needed topped. Checked the tire pressure to 32 PSi. 2. Tire tread depth – LF _8_/32, RF _8_/32, RR _6_/32, RL 6__/32. 3. TIRE ROTATION – Yes / No, If "No" – Then when? 4. Preformed basic safety inspection. Job Completed.
recommend resistor and rechecking system
test drove as needed slight brake pulsation noted front pads 6mms rear pads 5 mms lr rotor has poor pad contact fluids suspension drivetrain checked ok at this time
Adam W. gave our service a 5 star review on 12/5/2020